NEC MA Series 43" 4K Commercial Display with Media Player and Raspberry Pi Compute Module 4 SoC - Manual (Page 110)

English−106
SYSTEM MENU
CLONE SETTING
CLONE SETTING Copies some of the OSD menu settings to other monitors using a USB storage device (FAT32) or a LAN
cable.
NOTE:
The selection of which settings to copy will be reset to default when the monitor is powered off.
TARGET INPUT There are two options, “CURRENT” and “ALL”.
CURRENT: Copies only the current input’s data.
ALL: Copies data for all of the inputs.
INPUT Copies the selected settings.
PICTURE
AUDIO
SCHEDULE
SLOT
NETWORK
PROTECT
SYSTEM
HTTP
COPY START
Exports the monitor settings to a connected USB storage device or monitors connected via LAN.
Highlight and press SET to select each setting that needs to be copied to the other monitors, or select
[ALL INPUT]. Highlight [YES] and press SET to start copying the settings.
POWER INDICATOR Turns [OFF] or [ON] the LED that indicates the monitor is powered on and in active mode. The monitor’s
power LED will not glow when this setting is [OFF].
MUTE SETTING Allows you to mute the monitor’s audio and video output.
AUDIO: Mutes the audio output when the remote control’s MUTE button is pressed.
VIDEO: Mutes the video output when the remote control’s MUTE button is pressed.
AUDIO & VIDEO: Mutes the audio and video output when the remote control’s MUTE button is pressed.
NOTE:
The MUTE setting is released in the following cases:
• If you change the [INPUT], turn off/on the main power switch, turn off/on with the ⏻ button on
the remote control or the main unit, return from power save, change the [MUTE SETTING],
change the [AUDIO MODE], when the volume is changed with the remote control or the main
unit key, or when the video signal (resolution/scanning frequency) is changed.
USB
PC SOURCE Select which device you want to use to control the monitor and a device connected to USB-A.
AUTO: Automatically selects the PC SOURCE type.
EXTERNAL PC: Select this option to use a PC when it is connected to the USB2 port.
OPTION: Select this option to use an Option board. If an option board is not installed, OPTION will not be
available as a selection.
COMPUTE MODULE: Select this option when a Raspberry Pi Compute Module and Interface Board is
installed. If a Raspberry Pi Compute Module is not installed, COMPUTE MODULE will not be available as
a selection.
NOTE:
• The options available depends on if internal PC sources are installed in the monitor or a device
is connected to USB-B.
• Internal USB upstream hub switches to a device connected to USB-B when [EXTERNAL PC]
is set.
USB POWER Supplies power to the USB Service (2A) port. Select [ON] to supply power during standby.
NOTE:
Power consumption by devices connected to this port depends on the USB devices.
EXTERNAL CONTROL Enable to allow the monitor to be controlled by a device connected to the USB-B port.
UPDATE FIRMWARE Updates the firmware by connecting the USB storage device (FAT32) that stores the FIRMWARE image
file (PAC file) to the monitor.
RESET Resets all SYSTEM settings back to factory settings, except for [LANGUAGE], [OSD ROTATION],
[KEY GUIDE], [DATE & TIME] and [DAYLIGHT SAVING].
FACTORY RESET
RESET All items are returned to factory shipment state.