NEC MA Series 43" 4K Commercial Display with Media Player and Raspberry Pi Compute Module 4 SoC - Manual (Page 101)

English−97
AUDIO MENU
EQUALIZER
TREBLE Accentuates or reduces the high frequency range of audio signals.
Press the + button to increase [TREBLE].
Press the – button to decrease [TREBLE].
BASS Accentuates or reduces the low frequency sound.
Press the + button to increase [BASS].
Press the – button to decrease [BASS].
ADVANCED
LINE OUT Selecting [VARIABLE] enables control of the line out level with the VOLUME button on the remote control
or monitor control panel.
AUDIO DELAY Select this option if there is a noticeable delay between the video image and the audio signal output. When
this option is on, the audio signal can be delayed for a period of between 0 and 100 milliseconds. This
allows delays in the video, that may occur due to video processing such as DEINTERLACE, to be matched
by an equal delay in the audio signal to avoid lip-sync errors.
AUDIO DELAY
DELAY TIME
AUDIO INPUT Selects the audio to be output during single screen display.
Selects the audio input source: [DisplayPort1], [DisplayPort2], [HDMI1], [HDMI2], [COMPUTE MODULE*]
and [OPTION*
1 ].
NOTE: This function is disabled when the following functions are active: [MULTI PICTURE], [QUICK
INPUT CHANGE], [DUAL DAISY CHAIN MODE] or if input is set to [DisplayPort1] then
[DisplayPort VERSION] is set to [1.4].
RESET Resets all AUDIO settings back to factory settings except for [AUDIO MODE].
*: This function is only available when Raspberry Pi Compute Module Interface Board and Raspberry Pi Compute Module are installed. See page 84 .
* 1 : This function depends on which Option Board you are using. This function is only available when Option Board is installed.
SCHEDULE
SCHEDULE MENU
SCHEDULE SETTINGS
Creates a working schedule for the monitor (see page 41 ).
Press the  ,  , +, – buttons to navigate and change the schedule settings. Press the SET/POINT ZOOM
button on the remote control or Input change buttons on the monitor to select settings.
SETTINGS Highlight the number and press SET/POINT ZOOM button to activate the schedule. The box next to the
number has an outline when the schedule is enabled. Up to 14 schedules can be created and enabled.
Press the + or – button to cycle through schedule numbers.
POWER Sets the monitor’s power state for the schedule. Select [ON] if you want the schedule to turn the monitor on
at the specified time. Select [OFF] if you want the schedule to turn the monitor off at the specified time.
TIME Set the start time for the schedule.
NOTE:
Fill in both fields for the TIME setting. If either field shows [--], the schedule does not run.
INPUT Select which video input to use for the schedule. To keep the active input when the schedule starts, make
sure the setting is [--].
If you do select a specific input, set [ON] at [POWER].
DATE
YEAR Select this option if the schedule is only going to run on one day or it is an irregular schedule.
MONTH
DAY
EVERY WEEK Select this option to have the schedule repeat every week.
OFF TIMER Powers off the monitor after the time period shown next to the slider. Press the + or – button on the remote
control to adjust the timer from 1 to 24 hours.
NOTE:
Schedules do not run when the [OFF TIMER] is set to [ON].
RESET Resets all SCHEDULE settings back to factory setting, except for [OFF TIMER].