AG Neovo DR-22G 22" Full HD Dental Monitor (White) - Manual (Page 28)

CHAPTER 3: USING THE LCD DISPLAY
28
3.1 Turning on the Power
1
Connect the power cord to the power adapter. Then
connect the power adapter to the DC power input at the
rear of the LCD display.
2
Press the POWER button to turn the LCD display on.
The LED indicator turns GREEN.
When the LCD display is turned on, press the POWER
button to turn off the LCD display.
The LED indicator turns off.
Note:
♦
The LCD display still consumes
power as long as the power
cord is connected to the power
outlet. Disconnect the power
cord to completely cut off
power.
3.2 Selecting the Input Source Signal
Notes:
♦
After selecting an input source
signal, the input source signal
message appears on the
screen briefly.
For example, HDMI is selected
the following message is
displayed.
H D M I I N P U T
♦
If the selected input source
signal is not connected to the
LCD display or is turned off, the
no signal message is displayed
on the screen.
N O
S I G N A L
♦
If the resolution or the graphics
card of the connected computer
is set too high, the input out of
range message is displayed.
I N P U T S I G N A L
O U T O F R A N G E
1
Press the button to call out the input source menu.
V G A
D V I
H D M I
D I S P L A Y P O R T
C O M P O S I T E 1
C O M P O S I T E 2
S - V I D E O
2
Press the
p
or
q
button to highlight an input source.
3
Press the
u
button to select the input source.
Chapter 3: Using the LCD Display
POWER button
LED indicator
SOURCE button