Nikon 4804 R1 Wireless Close-Up Speedlight System - Manual (Page 93)

93
z
Oth
er functions
6
Repeating (RPT) flash operation
What is Repeating flash operation
In Repeating flash operation, the Speedlight fires repeatedly during a single
exposure, creating stroboscopic multiple-exposure effects. This operation is
useful when shooting fast-moving subjects. When using cameras compatible
with CLS, the SU-800 controls the flash output of the remote flash units (such as
the SB-910, SB-900, SB-800), which are divided into three groups (A, B, and C),
independently for each group.
• Be sure to read the user’s manual of the Speedlight in use.
Usable Speedlight
SB-910, SB-900, SB-800, SB-700, SB-600
Notes on Repeating flash operation
• The SB-R200 cannot be used.
• Setting the flash units in group A or B to fire or cancel is not possible using the [A
B]
select button. Use the flash mode setting.
• Be sure to use fresh batteries and allow enough time for the flash to recycle between each
repeating flash session.
• Also, because of the slower shutter speeds, use of a tripod is recommended to prevent
camera/flash shake.
Items to be set in Repeating flash operation
The following items can be set on the SU-800 in Repeating flash operation.
• Channel number (1, 2, 3, 4)
• Group name (A, B, C)
• Setting the flash units in each group to fire or cancel
• Manual flash output level, the frequency and the number of repeating flashes per frame
Settings in the Repeating flash operation
Set the Commander/Close-up select switch on the
SU-800 to Commander function. Then, press and hold
down the [SEL](FUNC.) button for approx. 2 seconds
to toggle between the Repeating and Commander
flash operations.
• Confirm that the RPT is displayed.
Display in Repeating flash
operation