Nikon 4804 R1 Wireless Close-Up Speedlight System - Manual (Page 61)

61
z
F
unctions and use of the
SB
-R200
2
Using the SB-R200
1 Slide open the battery chamber lid
in the direction of the arrow.
2 Install the battery, then close the
battery chamber lid by sliding it into
place.
Use CR123A (3V) lithium batteries.
Replacing the battery
When the SB-R200’s battery power is
weak, the green ready-light blinks after the
power has been turned on or after the flash
has fired
• Replace the battery.
3 Slide the SB-R200’s Mounting Foot
into the Speedlight Stand AS-20’s
Speedlight Mounting Shoe and
slide the lock switch.
The Mounting Foot cannot be inserted in
reverse.
• Slide the lock switch until it stops and make
sure that the red part can no longer be seen.
u
Attaching the SB-R200 to the front of the lens
• The SB-R200 can be attached to the front of the lens using the Attachment Ring SX-1
(p. 31).
ON/OFF
ON/OFF
ON/OFF
WIR
ELE
SS
SPE
EDL
IGH
T
AS-20
LOCK LOCK