P. 30, Procedures for close-up flash operation, Installing batteries in the sb-r200 – Nikon 4804 R1 Wireless Close-Up Speedlight System User Manual
Page 30: Replacing the battery
Procedures for close-up flash operation
30
3
Installing batteries in the SB-R200.
1
Slide open the battery chamber lid
in the direction of the arrow.
2
Install the battery, then close the
battery chamber lid by sliding it into
place.
Use CR123A (3V) lithium batteries.
Replacing the battery
When the SB-R200’s battery power is
weak, the green ready-light blinks after the
power is turned on or after the flash has
fired.
• Replace the battery.
ON/OFF
ON/OFF
ON/OFF
WIR
ELE
SS
SPE
EDL
IGH
T