Nikon 4804 R1 Wireless Close-Up Speedlight System - Manual (Page 72)

3
Procedures for close-up flash operation
72
7 Setting a channel number on the SU-800.
Set the communication channel numbers of the
SU-800 and SB-R200. Press the [SEL](FUNC.)
button to display the channel number. Press the
[
W
] or [
X
] button to set the channel number
(blinking). Press the [SEL](FUNC.) button once
again and the channel number stops blinking. The
last channel number to blink is the one that has
been set automatically.
• Select one of the four available channels. The same
channel number is set for all groups.
• The channel number blinks during adjustment and
stops after blinking six times unless an adjustment is
made. The last channel number to blink is the one that
has been set automatically.
8 Setting a channel number on the SB-R200.
Rotate the [CHANNEL] select dial on the SB-R200
to set the channel number. Be sure to set the
same channel number as set on the SU-800.
9 Setting a group on the SB-R200.
Rotate the [GROUP] select dial on the SB-R200 to
set the group. Once set, the SB-R200 operates
according to the controls as set on the SU-800.
10 Compose a picture and shoot with flash.
Confirm that the red ready-lights on the SU-800
and SB-R200 are on, then release the shutter.
• For details on test firing, refer to page 88.
CHANNEL
2
3 4
1
GROUP
A
B
C
READY
LOC
E
L
SEL
A B