Flash operation using the r1, Installing batteries in the sb-r200, Replacing the battery – Nikon 4804 R1 Wireless Close-Up Speedlight System User Manual
Page 46
46
Flash operation using the R1
1
Installing batteries in the SB-R200.
1
Slide open the battery chamber lid
in the direction of the arrow.
2
Install the battery, then close the
battery chamber lid by sliding it into
place.
Use CR123A (3V) lithium batteries.
Replacing the battery
When battery power is weak, the
SB-R200’s green ready-light blinks when
the power is turned on or after the flash
has fired.
• Replace the battery.
ON/OFF
ON/OFF
ON/OFF
WIR
ELE
SS
SPE
EDL
IGH
T