Nikon 4804 R1 Wireless Close-Up Speedlight System - Manual (Page 70)

70
3
Procedures for close-up flash operation
Procedures for dual-light close-up flash operation
1 Press the [ON/OFF] buttons to turn on the camera,
SU-800 and SB-R200.
• Ensure that the red ready-lights on the SU-800 and
SB-R200 are on.
• Confirm that Wireless flash, close-up mode and CLS-
compatible camera indicators are correctly displayed
on the SU-800
2 Selecting dual-light flash operation.
Press and hold the [SEL](FUNC.) button for
approx. 2 seconds to toggle between “dual-light”
and “triple-light” close-up flash operations.
• “Dual-light” is preset when shipped from the factory.
3 Setting the flash mode on the SU-800.
Press the [MODE] button to set the flash mode to
TTL or M (manual).
• “TTL” is preset when shipped from the factory.
• The same flash mode is set for both Groups A and B.
4 Setting the SB-R200 to fire or cancel.
Press the [A B] select button to set flash firing/
canceled for group A or B.
• The flash-canceled group name disappears.
• In dual-light close-up flash operation, you cannot
cancel flash firing for Groups A and B.
• Once set to flash canceled mode, flash output-level
ratio in TTL mode becomes invalid, while the flash
output level compensation values are retained.
• Even if the flash mode is set to flash canceled, flash
output level compensation values in the M (manual)
mode are retained.
Display in dual-light close-
up flash operation
READY
MODE
NO AF-ILL SE
A
ON/OFF A B
ON/OFF
READY
LOCK
MODE
NO AF-ILL
SEL
A B