Solutions to problems using content playback – Epson PowerLite 800F 5000-Lumen Pixel-Shift Full HD Ultra-Short Throw Laser 3LCD Projector (White) User Manual

Page 265

265

• If you do not hear sound from an HDMI source, set the connected device to PCM output.

• Make sure any connected audio cables are labeled "No Resistance."

• If you are using a Mac and you do not hear sound from an HDMI source, make sure your Mac

supports audio through the HDMI port. If not, you need to connect an audio cable.

• If you want to use a connected audio source when the projector isn't projecting any images, set the

Quick Startup

option in the Operation menu to

Off

and make sure the

A/V Output

setting in the

Signal I/O menu is set to

Always On

• If the volume for the computer is set to the minimum while the projector's volume is set to maximum,

the sound level may be mixed. Turn up the computer's volume and decrease the projector's volume
(when using Epson iProjection [Windows/Mac]).

• Make sure the

Audio Output Device

option is set to the correct audio port for your video device.

• If you turn the projector on immediately after turning it off, the cooling fans may run at high speed

momentarily and cause an unexpected noise. This is normal.

Parent topic:

Solving Image or Sound Problems

Related references

Input Signal Settings - Signal I/O Menu

Solutions to Problems Using Content Playback

If you cannot play back a playlist correctly, try the following solutions:

• Check the following on all projectors:

• All projectors are the same model. If any of the projectors are a different model or have a different

resolution, synchronized playback may not be performed properly.

• Make sure the name, date, and time settings are correct.

• Make sure all projectors are connected to the same network.

• Make sure the

Content Playback

setting is turned on in the Operation menu.

• Make sure your USB device contains a playlist.