Epson WorkForce ST-M3000 Monochrome MFP Supertank Printer - Manual (Page 270)

270
• Do not put opened ink bottles in the box with the product.
• Do not carry the product by its control panel; this may damage the product.
Note: Before storing your product for a long period, replace low, expended, or expired ink to help
prevent the print head from drying out. Store your product in a cool, dry place.
1. Turn off the product.
2. Open the printer cover and check to see if the print head is in the far right position (the home
position). If not, turn on the product, wait for the print head to move to the far right, then turn the
product off again.
3. Secure the print head to the case with tape.
Caution: Do not place tape on the white flat cable or ink tubes inside the product; otherwise, you
may damage your product.
4. Remove all the paper from the product.
5. Unplug the power cable.
6. Disconnect any connected cables.