Epson WorkForce ST-M3000 Monochrome MFP Supertank Printer - Manual (Page 158)

158
6. Change any of the displayed settings on the Scan tab as necessary.
7. Select the Advanced Settings tab to view and change additional scan settings, if necessary.
8. On the Scan tab, press the start button to start scanning.
Your product scans your original and saves the scanned file to the selected destination.
Parent topic: Starting a Scan Using the Product Control Panel
Setting Up a WSD Port (Windows 7/Windows Vista)
You can scan to a networked Windows computer using WSD (Web Services for Devices). You must first
set up a WSD port on your Windows 7 or Windows Vista system (the port is set up automatically on
Windows 10 and Windows 8.x).
Before you set up a WSD port, make sure you installed your product software, and connected your
product and computer to the same network.
1. Turn on your product.
2. Print a network status sheet so you can identify the network name and model name for your product
on the network.
3. Click or Start and select Computer .
4. On the left side of the window, select Network .
5. Locate your product on the Network screen, right-click it, and select Install .
6. When you see the User Account Control screen, click Continue .
Note: If you see an Uninstall screen, click Uninstall and repeat these steps as necessary.
7. When you see the message Your device is ready to use in the Windows taskbar, click the
message.
8. On the Driver Software Installation screen, make sure your product is listed as Ready to use . Then
click Close .
9. Do one of the following:
• Windows 7 : Click and select Devices and Printers .
• Windows Vista : Click Start and select Control Panel > Hardware and Sound > Printers .
10. Make sure that an icon appears for your product's name on the network.
When you use WSD, select your product name to scan over the network.