Sony ZRD-B12A Micro LED Video Wall Modular Display - Manual (Page 22)

22
Synchronizing with
External Sync Signals
Inputting External Sync Signals
Input the external sync signal to the REF IN
(external sync signals input) connector on the
primary controller via a BNC cable.
The following external sync signals are
supported.
• HD tri-level sync (0.6 Vp-p/75Ω/negative sync)
• SD black burst/composite sync (0.286 Vp-p/
75Ω/negative sync)
Enabling External Synchronization
If a primary controller is not configured with
Display Control Software or the primary
controller is not turned on, the external
synchronization cannot be enabled.
1
Select [Function] in the main screen of
Display Control Software, and then select
[Sync Settings].
2
Select [External Sync Signal] for [Sync
Signal Selection] in the [Sync Settings]
screen.
External synchronization is enabled
immediately.
Adjusting the light-up delay time for
Display Cabinets
Use the slider and buttons for [Cabinet Light
Delay] under [Sync] to specify the light-up delay
time (0 to 4000).
Synchronizing with the camera
being used for shooting
You can make changes to the settings under
[Camera Synchronized] in the [Sync Settings]
screen to reduce the appearance of black bars
that may occur in captured images when
shooting an LED display.
This function is not available when the Display
Cabinet is ZRD-CH12D/ZRD-CH15D/ZRD-BH12D/
ZRD-BH15D.
• The settings for synchronization with the
camera being used for shooting are available in
Display Control Software v01.01.00 or later.
• Input an external sync signal to the camera and
controller, enable the external sync setting,
then enable the mode.
Note
Caution
Caution
Notes