Sony ZRD-B12A Micro LED Video Wall Modular Display - Manual (Page 16)

16
Adjusting the Picture
Quality
Adjust the contrast, brightness, and other picture
quality settings.
The settings configured on the primary controller
will be applied to all the other Display
Controllers, including the sub controllers. Sub
controllers cannot be configured individually.
If the a primary controller is not configured via
Display Control Software or the primary
controller is not turned on at the time the [Picture
Settings] screen is displayed, picture quality
adjustment cannot be performed. In addition,
the picture quality settings will not be applied to
the sub controllers if they are not turned on.
1
Select [Picture Settings] in the [Array] menu
on the main screen of Display Control
Software.
2
Configure each setting.
The values currently configured on the
primary controller are displayed on the
[Picture Settings] screen.
The settings are reflected in the picture
immediately after they are configured.
[Picture Mode]: Select from [Mode1] to
[Mode100] to display the setting values
for [Contrast] to [Color Temperature
Settings]. If necessary, change the values
for [Contrast] to [Color Temperature
Settings]. The setting values are identical
for each mode under factory default
settings.
[Copy From]: The setting value from other
Picture Modes can be copied to the
selected Picture Mode.
[Rename]: A desired name can be
assigned to the selected Picture Mode.
[Contrast]: Use the slider and buttons to
adjust the contrast.
Setting range: 0 to 1000
Default value: 600
[Brightness]: Use the slider and buttons
to adjust the brightness.
Setting range: 0 to 1000
Default value: 500
[Gamma]: Select the gamma correction
value.
• [1.8]
• [2.2] (default value)
• [2.4]
• [2.6]
• [DICOM SIM]
• [Custom6] to [Custom10]
• This product is not a medical device. The
device cannot be used for medical
examinations, even when [DICOM SIM]
is selected.
• The [Gamma] settings will be disabled if
[HDR] is set to a setting other than [Off].
• [Custom6] to [Custom10] are settings
used for maintenance services.
[HDR]: Select the playback mode for HDR
(high dynamic range) content.
This setting takes priority over the value
set for [Gamma] except when [Off] is
selected.
• [SMPTE ST 2084]: Display SMPTE ST
2084 standard HDR images in a format
suitable for the display cabinet model
selected in [Cabinet Allocation]. (For
details, refer to the Installation Manual.)
• [SMPTE ST 2084 (Sim.)]: Display SMPTE
ST 2084 standard HDR images scaled to
the maximum brightness for the display
cabinet.
• [ITU-R BT.2100 (HLG)]: Display the HLG
(Hybrid Log Gamma) image specified by
recommendation ITU-R BT.2100.
• [S-Log3]: Display S-Log3 HDR images.
• [S-Log3 (Live)]: Display the HDR image
with system gamma added to the S-Log3
input signals.
• [SMPTE ST 2084 (B/BH Series)]: Display
SMPTE ST 2084 standard HDR images
formatted for ZRD-BH12D/B12A or ZRD-
BH15D/B15A.
Caution
Caution