Sony ZRD-B12A Micro LED Video Wall Modular Display - Manual (Page 14)

14
[DisplayPort (Dual)]: Use two DisplayPort
connectors to display pictures as large as
4K 100p/120p.
If you are only inputting single-stream
signals that are 50p/60p or lower, we
recommend clicking [Detailed Input
Settings] and clearing the [High Frame
Rate Mode] checkbox in the [Detailed
Input Settings] screen.
3
Click [OK] or [Apply] to apply the settings.
The setting values will be registered to the
Display Controller and saved to Display
Control Software.
Changing the Display Starting
Positions of Pictures
You can change the display positions for each
picture.
For example, you can move a low-resolution
picture from the top left of the screen to the
center.
1
Click [Detailed Input Settings] in the [Input
Settings] screen.
The [Detailed Input Settings] screen appears.
2
Click the tab ([DisplayPort (Single1)],
[DisplayPort (Single2)], [DisplayPort
(Dual)], [HDMI1], or [HDMI2]) of the video
signal for which you want to change the
display starting position.
3
Use the sliders and buttons for [H
Position] and [V Position] to specify the
horizontal and vertical positions.
The settings are reflected in the picture
immediately after they are configured.
For details, refer to the Installation Manual.
4
Click [Close].
The [Detailed Input Settings] screen closes.
Note