Sony ZRD-B12A Micro LED Video Wall Modular Display - Manual (Page 18)

18
A desired name cannot be assigned when
D93/D65/D50/DCI is selected.
3
Configure the Gain and Bias values.
These settings can only be configured when
[Color Temperature Settings] is set to a
setting value from [User1] to [User40] in step
2.
Use the slider and
buttons to adjust the
Gain and Bias values.
[Gain]
Setting range: 0 to 1023
Default value: (value equivalent to D65)
[Bias]
Setting range: -512 to 511
Default value: 0
The output brightness after adjusting the
image quality is displayed in [Adjustment
Light Level] as a ratio to the maximum
brightness.
4
Set the Advanced Picture function.
Select [Advanced Picture] to display the
[Advanced Picture Settings] screen.
[Normal]: Display the picture faithfully
according to the input signal.
[Advanced]: Change the settings of the
Reality Creation, Motionflow, and Wide
Mode functions.
• When using the [Reality Creation] or
[Global Scaling] function with multiple
Display Controllers, it is necessary to set
the cabinet placement address with this
in mind. For details, refer to the
Installation Manual.
• Even when [Advanced] is selected,
images are displayed in [Normal] in the
following cases.
– The frame rate of the input signal is
higher than 60p.
– [3D Frame Sequential Mode] or [3D
Dual Input Mode] is selected in the [3D
Settings] screen.
[Reality Creation]: Adjust the definition and
noise processing. (Super resolution
function)
• [ON]: Change the settings of the Reality
Creation function to improve the texture
and sense of detail.
[Reality]: Use the slide lever and to
adjust the definition.
[Clarity]: Use the slide lever and to
adjust the noise processing.
• [OFF]: Turn off the Reality Creation
function.
[Motionflow]
• [OFF]: Turn off the Motionflow function.
• [1] to [5]: The larger the setting value,
the smoother the motion.
• Depending on the picture, changing the
settings may have no effect.
• When using multiple Display
Controllers, the [Motionflow] function
cannot be used (depending on the
picture, parts of the picture may appear
disjointed or not continuous). Have
[OFF] selected for the [Motionflow]
function when using multiple Display
Controllers.
[Wide Mode]
• [Normal]: Fit an image into the screen
size without being cut off while its
aspect ratio is maintained.
• [Full]: Fit an image into the screen size
without being cut off by changing its
aspect ratio.
• [Zoom]: Cut off an image to fit into the
screen size with its aspect ratio
maintained.
• [Stretch]: Display standard TV signals
(SD signals) in a 16:9 aspect ratio. For
signals other than standard TV signals,
the display will be the same as Normal.
• [Native]: Display the input image in dot-
by-dot format.
Caution
Note
Caution
Caution