Yaskawa MP900 Series MPLOGGER - Manual (Page 93)

7 Log Database Configuration
7-2
7.1 Controller Information Database
Information for the Communications Driver and controller that was set up through the PLC
Menu is stored in this database. A folder named “Data” is created in the folder where MPLOG-
GER is installed. Inside the folder is an MDB file with the same name as the workbook created
using the ntlp
Creating a New WorkBook section.
„ ComDeviceTable
This table stores the communications driver settings and is not specifically required to
search log data.
„ DriverAssignTable
This table stores information for communications driver assignment and is not specifically
required to search log data.
Field Name Data Format Description
DeviceID Long integer Communications port identifier
DeviceType Integer Communications device type
1 to 9: COM port, 10: Ethernet, above 20: Assigned special device
DeviceName Text Communications port name (e.g., COM1, COM2, or EtherCard.....)
Param0 Text Communications parameter 0
Param1 Text Communications parameter 1
Param2 Text Communications parameter 2
Param3 Text Communications parameter 3
Param4 Text Communications parameter 4
Param5 Text Communications parameter 5
Param6 Text Communications parameter 6
Param7 Text Communications parameter 7
Param8 Text Communications parameter 8
Param9 Text Communications parameter 9
Field Name Data Format Description
AssignID Long integer Communications device assignment list identifier
DriverName Text Driver name
DriverShortName Text Driver short name
DeviceID Long integer Communications port identifier
InitialFile Text Initial information file name