Yaskawa MP900 Series MPLOGGER - Manual (Page 123)

Appendix A
A.1.4 Input Parameters
A-8
A.1.4 Input Parameters
„ EXECUTE (Receive Command)
When this command is ON, message reception has started. The command must be held ON
until either COMPLETE or ERROR turns ON.
„ ABORT(Abort Reception Command)
When this command is ON, reception is aborted. This command has a higher priority than
the EXECUTE command.
„ DEV-TYP (Communications Device Type)
Specifies the communications device type.
„ PRO-TYP (Communications Protocol)
Specifies the communications protocol. To communicate with the MELSEC protocol, spec-
ify the MEMOBUS protocol to (= 1). The protocol is converted by the Communications
Device (217IF and 218IF).
• MEMOBUS: Setting = 1
• Non-procedure 1 : Setting = 2 (Non-procedure, receives data in words.)
• Non-procedure 2 : Setting = 3 (Non-procedure, receives data in bytes.)
Note: Non-procedure communications do not send a response to the other
terminal.
„ CIR-NO (Circuit Number)
Specifies the circuit number.
„ CH-NO (Channel Number)
Specifies the channel number. Make sure that each channel number is used only once in the
same circuit.
Device Type Code
217IF 5
218IF 6
SVB 10
260IF 11
Device Channel
Number
217IF 1
218IF 1 to 10
260IF 1 to 4