Yaskawa MP900 Series MPLOGGER - Manual (Page 43)

4.6 Controller Settings
4-13
4
3. Registering the controller.
The selected logical port defines the parameters displayed in the section circled in the
above dialog box. Click the
Add Button to add it to the Current Assignments List on the
right. When all the controllers have been registered, click the Close Button to close the
dialog box.
The Logical Port Pull-down List lists only ports that were assigned to a driver in 4.5.1
Communication Setting Dialog Box .
a) Controller Setting Dialog Box for Memobus
Specify the CPU serial address (Machine No.) of the controller corresponding to the
selected port. The CPU serial address can be anything from 1 to 63. It must match the
communications settings in the Communications Module of the controller. Each con-
troller can be assigned a device name. The device name can be up to 20 characters
long.
b) Controller Setting Dialog Box for CP-218
Specify the IP address of the controller corresponding to the selected port.
Also, specify the port number to be used.
Specify the protocol to be used. (Select from TCP or UDP.) The above settings must
match the communications settings of the Communications Module of the controller.
Each controller can be assigned a device name. The device name can be up to 20
characters long.