Yaskawa MP900 Series MPLOGGER - Manual (Page 64)

4 Basic Operation
4.9.2 Tag Settings
4-34
4.9.2 Tag Settings
1. To add tags to a tag group, select the desired tag group from the Tag Group List in the
Tag Group Setting Dialog Box and click the Tag Setting Button. The Tag Setting Dia-
log Box will be displayed.
The lower part of the dialog box will display a list of tags that are registered in that tag
group.
New tags can be added or existing tags modified by entering the tag settings in the top
half of the dialog box.
2. Adding Tags
Enter the tag settings in the top half of the dialog box, and then click the Add Button to
add it to the tag list. If the tag name already exists, an error will occur, and you cannot
add the tag.
To add another tag, modify the items and click the
Add Button again. If the parameters
are invalid, a message box will appear.
The Tag Setting items are described below.
• Logical Port
Select the logical port that connects to the desired controller. Select it from the Com-
munications Ports List in the communications driver settings.
• Controller
The device name that was assigned in the controller settings will be displayed here.
• CPU No.
The CPU number can be specified by clicking the Detail Button. If the MP920 or
CP-9200SH is used in a multi-CPU environment, use CPU number 1 or 2. Other
controllers should be set to 1.
• Tag Name (Mandatory)
Any name can be assigned. Each tag name must be unique within each tag group.