Yaskawa MP900 Series MPLOGGER - Manual (Page 49)

4.7 Communications Cell Settings
4-19
4
4.7.2 Read Cells
Right-click the cell and select Cell Communications Setup - YASKAWA Cell Setting from
the pop-up. The a dialog box to set a communications cell will be displayed as shown below.
(Shown with default settings.)
The values that are displayed in the dialog box are the previously set values.
1. Check that the R/W selection Option is set to Read .
2. Set the cell settings so that the desired controller data can be read.
3. When the settings have been completed, click the OK Button.
4. The dialog box will close and the cell setting will be saved.
5. If the address setting is incorrect, a message box will appear.
6. Cells that are set to read data will be outlined.
• Logical Port
Select the logical port that connects to the desired controller. Select it from the Com-
munications Ports List in the communications driver settings.
• Device
The device name that was assigned in the controller settings will be displayed here.
• CPU No.
The CPU number can be specified by clicking the Detail Button. If the MP920 or
CP-9200SH is used in a multi-CPU environment, use CPU number 1 or 2. Other con-
trollers should be set to 1.
• Addressing Scheme
Specifies the addressing scheme.
Register Number and Reference Number can be selected. The register type and
address settings depend on the addressing scheme.
• Register Type
Select the desired register type of the controller. It can be chosen from MB, MW, ML,
MF, IB, IW, IL, and IF.
Address