Yaskawa MP900 Series MPLOGGER - Manual (Page 20)

3 Installation
3-2
3.1 CimScope Installation Procedure
MPLOGGER uses a communications driver called CimScope (the Communication Manager) to
communicate with the controllers. This is the first software that needs to be installed. The instal-
lation and setup procedure is as follows.
Once the installation has been completed using the Installer, refer to Chapter 9 Communication
Manager Settings to set up the driver.
1. Turn ON the personal computer and start Windows.
If Windows is already running, close all open applications on your computer.
2. Insert the MPLOGGER setup CD-ROM into the CD-ROM drive.
3. Click the Windows Start Button and select RUN...
4. Wait until the Run Dialog Box is displayed. Enter the CD-ROM drive and the filename
as shown below. Then click the OK Button. (In the example below, the CD-ROM drive is
E: .)