ProSoft Technology MVI69-ADM - Manual (Page 226)

Backplane API Functions MVI-ADM ♦ 'C' Programmable
Developer's Guide 'C' Programmable Application Development Module
Page 226 of 342 ProSoft Technology, Inc.
February 20, 2013
MVIbp_GetSetupMode
Syntax
int MVIbp_GetSetupMode(MVIHANDLE handle, int *mode);
Parameters
handle Handle returned by previous call to MVIbp_Open
mode Pointer to an integer that is set to 1 if the Setup Jumper is
installed, or 0 if the Setup Jumper is not installed.
Description
This function queries the state of the Setup Jumper.
handle must be a valid handle returned from MVIbp_Open.
mode is a pointer to an integer. When this function returns, mode will be set to 1
if the module is in Setup Mode, or 0 if not.
If the Setup Jumper is installed, the module is considered to be in Setup Mode. It
may be useful for an application to detect Setup Mode and perform special
configuration or diagnostic functions.
Return Value
MVI_SUCCESS No errors were encountered
MVI_ERR_NOACCESS handle does not have access
Example
MVIHANDLE handle;
int mode;
MVIbp_GetSetupMode(handle, &mode);
if (mode)
// Setup Jumper is installed - perform configuration/diagnostic
else
// Not in Setup Mode - normal operation