ProSoft Technology MVI69-ADM - Manual (Page 19)

MVI-ADM ♦ 'C' Programmable Preparing the MVI-ADM Module
'C' Programmable Application Development Module Developer's Guide
ProSoft Technology, Inc. Page 19 of 342
February 20, 2013
2.4 Cable Connections
The application ports on the MVI-ADM module support RS-232, RS-422, and RS-
485 interfaces. Please inspect the module to ensure that the jumpers are set
correctly to correspond with the type of interface you are using.
Note: When using RS-232 with radio modem applications, some radios or modems require
hardware handshaking (control and monitoring of modem signal lines). Enable this in the
configuration of the module by setting the UseCTS parameter to 1.
2.4.1 RS-232 Configuration/Debug Port
This port is physically an RJ45 connection. An RJ45 to DB-9 adapter cable is
included with the module. This port permits a PC based terminal emulation
program to view configuration and status data in the module and to control the
module. The cable for communications on this port is shown in the following
diagram:
2.4.2 RS-232 Application Port(s)
When the RS-232 interface is selected, the use of hardware handshaking
(control and monitoring of modem signal lines) is user definable. If no hardware
handshaking will be used, here are the cable pinouts to connect to the port.