PLANET IPM-1200x Series - Manual (Page 16)

the IP Power Manager’s outputs remotely.
The following procedure describes the basic steps needed to set up the IP Power Manager:
a. To set up the hardware, connect power to the power inlet and output devices to
the power outlets. Connect devices with normally open or normally close
conditions to the digital output ports, and an EMD to the console port.
b. To configure the IP Power Manager, users can use the console or LAN port. Connect the
IP Power Manager to a console and a LAN to enable its configuration through the
console or browser menu.
c. After connecting to a console, use a console application such as Telnet or HyperTerminal
to access the console menu. Select the System Group submenu under the IP Power
Manager Configuration to set up the IP address and the system date/time. This IP
address will be used while accessing the web interface to configure the IP Power
Manager parameters.
d. After connecting to LAN, open a browser from a PC in the network and use the IP Power
Manager’s IP address specified through the console menu to open the web interface for
system configuration.
Step 5 Connecting Input Power
The IP Power Manager has an IEC C20 power inlet for supplying and managing power for
the output devices. Connect the power cord to the power inlet and plug the other end into a
power outlet as shown:
- 11 -
User’s Manual of IPM-1200x Series