PLANET WNAP-7205 User Manual
Page 61
User’s Manual of WNAP-7205
Step 2.
Go to “Wireless Settings-> WDS”, fill in the MAC Address of the remote site.
Figure 5-27 WDS Configuration
1. To Setup the WDS Connection, the channel must be the same in both sites. You
should fix the channel from “AutoSelect” to a static one.
2. You must fill in the MAC Address by each other. For example, enter the MAC
Address of the remote site to the settings of local site; and enter the MAC Address
of the local site to the settings of remote site.
3. The Encryption Type must be the same in both sites if available.
c. AP+WDS (Repeater) Mode
Repeater mode allows user to operate as a wireless repeater, extending the range for remote wireless
clients and connecting them to an AP connected to the wired network. The MAC addresses of WDS
peers must be configured on the Wireless 2.4G Access Point/Repeater.
- 61 -