PLANET WNAP-7205 - Manual (Page 22)

User’s Manual of WNAP-7205
3.2.2 Pole Mounting
Step 1. Turn the WNAP-7205 over. Put the pole mounting tie through the middle hole of it.
Step 2. Mount WNAP-7205 steadily to the pole by fastening the mounting tie tightly.
Step 3. Now you have completed the hardware installation of WNAP-7205 as figure below.
Mounting Tie
Figure 3-6 Pole Mounting
3.2.3 Using the External Antenna
If you prefer to use the external antenna with RP-SMA Type connector for your application instead of
the built-in directional antenna, please follow the steps below.
Step 1. Connect your antenna with the RP-SMA Type connector on the bottom of WNAP-7205.
Step 2. Power on the WNAP-7205, and then go to Wireless Settings-> Basic to configure the
Antenna Switch from “Internal” to “External”.
1. If you are going to use an external antenna on WNAP-7205, get some cable in
advance.
1. Users MUST power off the WNAP-7205 first before connecting the external
antenna to it. Do not switch from built-in antenna to the external antenna from
WEB management without physically attaching the external antenna onto the
WNAP-7205 ; otherwise, damage might be caused to the WNAP-7205 itself.
- 22 -