PLANET VRT-420N - Manual (Page 59)

Using the [ping] tool based on the instructions listed below
Interface Select the interface that use to ping to, ie. WAN1,WAN2, LAN.
Target Host Enter the IP address to ping to
Number of Packets Specify the number of the ICMP packets to send out
Ping Press the tab to start the “ping” actions
Using the [ARPing] tool based on the instructions listed below
Interface Select the interface that use to ARPing to, ie.WAN1,WAN2, LAN
Target Host Enter the MAC address to ARPing to
Number of Packets Specify the number of the ARP request packets to send out
ARPing Press the tab to start the “ARPing” actions
Using the [Trace Route] tool based on the instructions listed below
Interface Select the interface that use to ARPing to, ie. WAN1, WAN2.
Target Host Enter the destination IP address / domain name to trace
Hop Count Specify the Hop number you need to trace
Trace route Press the tab to start the “Trace Route” actions
7.3 Time
Click on [Setup] – [Time] tab. You will see the following screen.
59