PLANET VRT-420N - Manual (Page 45)

Configure [Add - IPsec] Settings following the instructions below.
Sequence Number This defines the sequence of the IPsec rules.
Connection Name Name of the IPsec rule.
Rule Enable Enable/Disable this IPsec rule
VPN Mode Net-to-Net or Road Warrior
Local External Interface Choose the external WAN for the local VPN gateway.
Local Internal IP Address Choose the subnet IP address for the VPN gateway.
Local Netmask Choose the netmask for the local VPN gateway.
Remote Gateway Enter the IP address or domain name of the remote VPN gateway. This option is
needed in Net-to-Net mode.
Remote Subnet IP Enter the subnet IP address of the remote VPN gateway. This option is needed in
Net-to-Net mode.
Remote Netmask Enter the subnet netmask of the remote VPN gateway. This option is needed in
Net-to-Net mode.
Connection Initiation Check the local VPN gateway to initiate the connection. This option is needed in
Net-to-Net mode.
IKE Key Mode PSK.
Preshared Key Enter the preshared key. The key should be at least 8-digit ASCII string.
DPD Enable “Dead Peer Detection” A Traffic-Based Method of Detecting Dead IKE Peers
DPD Interval The interval time for DPD.
DPD Timeout It takes how long the DPD will seem this connection timeout.
Advanced Options Check it if you need to configure the advanced options.
Phase 1 Mode Main.
Phase 1 ID Enter the phase 1 ID.
Phase 1 Lifetime Enter the phase 1 lifetime. This value is between 3600 and 28800 seconds.
Phase 2 Lifetime Enter the phase 2 lifetime. This value is between 3600 and 28800 seconds.
Phase 1 Authentication Choose the phase 1 authentication as MD5 or SHA1.
Phase I Encryption Choose the phase 1 encryption as DES, 3DES or AES.
Phase 1 Group Key
Management
Choose the phase 1 group key management as DH1, DH2 or DH5.
Phase 2 Authentication Choose the phase 2 authentication as MD5 or SHA1.
Phase 2 Encryption Choose the phase 2 encryption as DES, 3DES or AES.
Phase 2 Group Key
Management
Choose the phase 2 group key management as DH1, DH2 or DH5.
45