PLANET VRT-420N - Manual (Page 52)

Add Port Range Forwarding Rule
Click on [Add] tab. You will see the following screen.
Configure [Add Port Range Forwarding Rule] Settings following the instructions below
Sequence Number
This defines the sequences (priorities) of the port forwarding rules. If a packet fits
the conditions setup by the port forwarding rules, the packet will then be forwarded
according to the 1st rule from the top of the list.
Rule Name Enter the name of the port forwarding rule.
Rule Enable Check/Uncheck to enable/disable this port forwarding rule.
External Interface Choose WAN1 or WAN2 as the External port forwarding interface.
Protocol Choose TCP, UDP or TCP/UDP for the rule to be applied.
External Port Range Set up the External Port Range for the rule to be applied.
Internal IP Set up the Internal IP for the rule to be applied.
Internal Port Range Set up the Internal Port Range for the rule to be applied.
6.2 Virtual Host
52