PLANET VRT-420N - Manual (Page 19)

In this WISP mode, the wireless client will connect to ISP access point. The NAT is enabled and PCs in
Ethernet ports share the same IP to ISP through wireless LAN. You must set the WAN port to WISP mode
first and connect to the ISP AP in Site-Survey page. The connection type can be setup in WAN page by
using PPPOE, DHCP client, PPTP client or static
IP.
Please the Click “Next” button to proceed to the next step.
4.1.2WAN Advance
1.Configure the [Setup] -[WAN Advance] following the instructions below.
19