PLANET IVC-2002 - Manual (Page 6)

6
1.2 Ethernet over VDSL2 Bridge Description
PLANET’s state-of-the-art Ethernet-over-VDSL2 products are based on
two core networking technologies: Ethernet and VDSL2 (Very-high-
data-rate Digital Subscriber Line 2). This technology offers the
absolute fastest possible data transmission speeds over existing copper
telephone lines or coaxial cables without the need for rewiring.
The IVC-2002 Industrial Ethernet Extender has a switching architecture
with 4 RJ-45 10/100Mbps Ethernet port and one asymmetric or
symmetric Ethernet over VDSL port (Asymmetric means upstream and
downstream rate are not the same and Symmetric means upstream
and downstream rate are similar) – the VDSL port can be RJ-11 or
BNC Connector. The IVC-2002 can set to Master or Slave mode via a
DIP switch. When IVC-2002 (RJ-11) is connected with other IVC-2002
device, the performance will up to 99/63Mbps for asymmetric data
rate within 200m and up to 28/2Mbps at 1.4km. The IVC-2002 (BNC)
performance is up to 99/65Mbps for asymmetric data rate within 200m
and up to 31/4Mbps at 2.4km. This capability is ideal for use as an
Ethernet extender for your existing Ethernet network.
The IVC-2002 Industrial Ethernet Extender with slim type of IP-30
metal shape for easily deployment in Heavy Industrial demanding
environments.
PLANET Industrial Ethernet Extender provides a lower cost replacement
and smooth migration for existing Long Reach Ethernet (LRE)
networks.
The cable specifications of the connection are listed as following:
10Base-T, Category 3, 4 or 5 UTP l
100Base-TX, Category 5, 5e or 6 UTP l
Ethernet over VDSL2, Twisted-pair Telephone Wires l
Ethernet over VDSL2, Coaxial Cable l
Note
Slave device (CPE) must connect to Master device (CO)
through the telephone wire or coaxial cable. It is not
allow connecting like Master to Master or Slave to Slave.
To define the IVC-2002 to Master or Slave, please refer
to section 2.1.2 for more detail.