PLANET IVC-2002 - Manual (Page 19)

19
3.4 Wiring the Power Inputs
The 6-contact terminal block connector on the top panel of Industrial
Ethernet Extender is used for two DC redundant powers input. Please
follow the steps below to insert the power wire.
1. Insert positive / negative DC power wires into the contacts 1 and 2
for POWER 1, or 5 and 6 for POWER 2.
Input
DC12~48V V1- V1+ V2- V2+
PWR1 PWR2 Fault
V1- V1+ V2- V2+
2. Tighten the wire-clamp screws for preventing the wires from loosing.
1 2 3 4 5 6
Power 1 Fault Power 2
- + - +