PLANET IVC-2002 - Manual (Page 21)

21
3.6 Mounting Installation
This section describes how to install the Industrial Ethernet Extender
and make connection to it. Please read the following topics and perform
the procedures in the order being presented.
Note
In the installation steps below, this Manual use IGS-
801 (PLANET 8 Port Industrial Gigabit Switch) as the
example. However, the steps for PLANET Industrial
Switch & Industrial Ethernet Extender are similar.
3.6.1 Install DIN-Rail Mounting
The DIN-Rail is screwed on the Industrial Ethernet Extender when
out of factory. Please refer to following figures to hang the Industrial
Ethernet Extender on track.
2
1
Step 1: Lightly press the button of DIN-Rail into the track.
Step 2: Check the DIN-Rail is tightly on the track.