PLANET IVC-2002 - Manual (Page 13)

13
2.1.2 MODE DIP Switch
The Industrial Ethernet Extender provides 4 selective transmission
modes. By switching the transmission modes, you can obtain a best
transmission mode to suit with phone line quality or distance of
connectivity. The following is the summary table of transmission setting,
bandwidth and distance extensibility tested for AWG 24 (0.5mm)
twisted-pair without noise and cross talk.
DIP Switch DIP-1 DIP-2 DIP-3 DIP-4
Function Mode Link Type Band Plan SNR
OFF Master RJ-11 Symm 9dB
ON (default) Slave BNC Asymm 6dB
Master / Salve l
t Master (Central Office) – the Master device mode, usually the
Master device will be located at the data center of ISP or enter-
prise to link to the backbone.
t Slave (Customer Premises Equipment) – the Slave device mode,
usually the Slave device will be located at branch office, home or
remote side as the long reach data receiver. The Slave also can be
connected to the PC, IP Camera or Wireless Access Point and etc
network devices.
Note
When the Industrial Ethernet Extender operate at Slave
mode, the DIP switch 2,3,4 is no function.
Link Type l
t BNC mode allows IVC-2002 to connect and data transfer by using
BNC cable
t RJ-11 mode allows IVC-2002 to connect and data transfer by using
Telephone Wire