PLANET WGSW-48040HP - Manual (Page 67)

User’s Manual of WGSW-48040HP
The Page includes the following fields:
Object Description
 Image The flash index name of the firmware image. The name of primary (preferred)
image is image, the alternate image is named image.bk.
 Version The version of the firmware image.
 Date The date where the firmware was produced.
Buttons
: Click to use the alternate image. This button may be disabled depending on system state.
4.2.24 Factory Default
You can reset the configuration of the Managed Switch on this Page. Only the IP configuration is retained. The new
configuration is available immediately, which means that no restart is necessary. The Factory Default screen in Figure 4-2-29
appears.
Figure 4-2-29: Factory Default Page Screenshot
Buttons
: Click to reset the configuration to Factory Defaults.
: Click to return to the Port State Page without resetting the configuration.
To reset the Managed Switch to the Factory default setting, you can also press the hardware reset button
at the front panel about 10 seconds. After the device be rebooted. You can login the management WEB
interface within the same subnet of 192.168.0.xx.
67