PLANET WGSW-48040HP User Manual
Page 28
User’s Manual of WGSW-48040HP
MGB-TLA20
1000
WDM(LC) Single Mode
20km
1310nm
1550nm
-40 ~ 75 ℃
MGB-TLB20
1000
WDM(LC) Single Mode
20km
1550nm
1310nm
-40 ~ 75 ℃
MGB-TLA40
1000
WDM(LC) Single Mode
40km
1310nm
1550nm
-40 ~ 75 ℃
MGB-TLB40
1000
WDM(LC) Single Mode
40km
1550nm
1310nm
-40 ~ 75 ℃
MGB-TLA60
1000
WDM(LC) Single Mode
60km
1310nm
1550nm
-40 ~ 75 ℃
MGB-TLB60
1000
WDM(LC) Single Mode
60km
1550nm
1310nm
-40 ~ 75 ℃
1. It is recommended to use PLANET SFP on the Managed Switch. If you insert an SFP
transceiver that is not supported, the Managed Switch will not recognize it.
2. Port 45 to Port 48 are a shared SFP slot that supports the Gigabit and Fast Ethernet SFP
transceiver.
In the installation steps below, this Manual uses Gigabit SFP transceiver as an example. However,
the steps for Fast Ethernet SFP transceiver are similar.
1.
Before we connect the WGSW-48040HP to the other network device, we have to make sure both sides of the SFP
transceivers are with the same media type, for example: 1000Base-SX to 1000Base-SX, 1000Bas-LX to 1000Base-LX.
2.
Check whether the fiber-optic cable type matches with the SFP transceiver requirement.
To connect to 1000Base-SX SFP transceiver, please use the multi-mode fiber cable with one side being the male
duplex LC connector type.
To connect to 1000Base-LX SFP transceiver, please use the single-mode fiber cable with one side being the male
duplex LC connector type.
Connect the Fiber Cable
1.
Insert the duplex LC connector into the SFP transceiver.
2.
Connect the other end of the cable to a device with SFP transceiver installed.
3.
Check the LNK/ACT LED of the SFP slot on the front of the Managed Switch. Ensure that the SFP transceiver is operating
correctly.
4.
Check the Link mode of the SFP port if the link fails. To function with some fiber-NICs or Media Converters, user has to set
the port Link mode to
“1000 Force” or “100 Force”.
Remove the Transceiver Module
1.
Make sure there is no network activity anymore.
2.
Remove the Fiber-Optic Cable gently.
3.
Lift up the lever of the MGB module and turn it to a horizontal position.
4.
Pull out the module gently through the lever.
28