PLANET WGSD-10020 - Manual (Page 29)

User’s Manual of WGSD / WGSW Layer 2+ Series
WGSW-24040R Front Panel
Figure 2-5 Front Panel of WGSW-24040R
WGSW-24040HP Front Panel
Figure 2-6 Front Panel of WGSW-24040HP
WGSW-24040HP4 Front Panel
Figure 2-7 Front Panel of WGSW-24040HP4
■ Gigabit TP interface
10/100/1000BASE-T copper, RJ45 twisted-pair: Up to 100 meters.
■ SFP slots
100/1000BASE-X mini-GBIC slot, SFP (Small Factor Pluggable) transceiver module: From 550 meters (Multi-mode fiber),
up to 10/30/50/70/120 kilometers (Single-mode fiber).
■ Reset button
On the left of the front panel, the reset button is designed to reboot the Managed Switch without turning off and on the
power. The following is the summary table of the reset button functions :
Reset Button Pressed and Released Function
< 5 sec : System reboot Reboot the Managed Switch
> 5 sec : Factory Default
Reset the Managed Switch to Factory Default configuration.
The Managed Switch will then reboot and load the default
settings as shown below:
。 Default Username: admin
。 Default Password: admin
。 Default IP address: 192.168.0.100
。 Subnet mask: 255.255.255.0
。 Default Gateway: 192.168.0.254
29