Avago Technologies Syncro 9361-8i User Manual
Page 23
Avago Technologies
- 23 -
Syncro CS 9361-8i and Syncro CS 9380-8e Controllers User Guide
November 2014
Chapter 2: Hardware and Software Setup
Syncro CS 9380-8e Two-Server Cluster Hardware Setup
5.
Ground yourself and then place the Syncro CS controller on a flat, clean, static-free surface.
NOTE
If you want to replace a bracket, refer to the Replacing Brackets on
MegaRAID SAS+SATA RAID Controllers Q at
ww.lsi.com/downloads/
for instructions.
J1A11
Global hard disk drive (HDD) activity LED
header
2-pin connector
Connects to an LED that indicates activity on the drives connected to
the
controller.
J1A12
SAS Port 0 through Port 7 external
connector
Two SFF-8644 mini-SAS HD-4e external connectors
Connects the controller by cable to an enclosure containing SAS drives.
J1B1
Advanced software options hardware key
header
3-pin header
Enables support for selected advanced features, such as Recovery,
FastPath, and SafeStore™ disk encryption.
Refer to the MegaRAID Advanced Software Options Hardware Key Quick
Installation Guide for more information.
J1B2
Cache write pending header
2-pin connector.
Connector for an LED mounted on the system enclosure. The LED
indicates that the data in the cache has yet to be written to the
storage
devices.
J1B3
LSI Test header
2-pin connector
Reserved for LSI use.
J1B4
On-board Serial Universal Asynchronous
Receiver/Transmitter (UART) connector
4-pin connector
Reserved for LSI use.
J2B4
Standard edge card connector
The interface between the RAID controller and the host system.
Along with the PCIe interface, this connector provides power to the
board and an I
2
C interface connected to the I
2
C bus for the Intelligent
Platform Management Interface (IPMI).
J4A1
CacheVault Flash Module (ONFI) interface 80-pin connector
Connects the RAID controller to a flash module.
Table
2 Syncro CS 9380-8e Jumpers and Connectors (Continued)
Jumper/
Connector
Type
Description
B
-$
YH
YH
D
N
B
-%
YH
YH
D
N