Avago Technologies Syncro 9361-8i - Manual (Page 10)

Avago Technologies
- 10 -
Syncro CS 9361-8i and Syncro CS 9380-8e Controllers User Guide
November 2014 Chapter 2: Hardware and Software Setup
Syncro CS 9361-8i Cluster-in-a-Box Hardware Setup
Figure 1 CiB Syncro CS 9361-8i Configuration
2.2 Syncro CS 9361-8i Cluster-in-a-Box Hardware Setup
Follow these steps to set up the hardware for a Syncro CS 9361-8i CiB configuration. The setup procedure might be
somewhat different for CiB models from different vendors, so be sure to also read the CiB manufacturer’s
documentation.
NOTE The Syncro CS solution includes two Syncro CS controllers, so you
must perform the installation procedure for both controllers, one in
each server module inside the CiB enclosure.
1. Unpack the controller kit in a static-free environment and check the contents. Remove the components from the
antistatic bags and inspect them for damage. If any components are missing or damaged, contact LSI or your
Syncro CS OEM support representative.
2. Turn off power to the CiB enclosure, if necessary, and unplug the power cords from the power supply. Remove the
cover from the CiB.
&OXVWHULQD%R[&KDVVLV
B
L6&6,
&OLHQWZLWK
$SSOLFDWLRQV
3ULYDWH/$1
1HWZRUN
'166HUYHU
6HUYHU1RGH
0RGXOH
L
3RUWV 3RUWV
6HUYHU1RGH
0RGXOH
L
3RUWV 3RUWV
3XEOLF/RFDO$UHD1HWZRUN/$1
L6&6,
&OLHQWZLWK
$SSOLFDWLRQV
L6&6,
&OLHQWZLWK
$SSOLFDWLRQV
6$66LQJOH/DQHV
6$6)RXU/DQHV
&L%([SDQGHU
%RDUG
&L%'ULYH%DFNSODQH
&L%([SDQGHU
%RDUG
([SDQGHU ([SDQGHU
6$6'XDO3RUWHG'ULYHV