Avago Technologies Syncro 9361-8i - Manual (Page 12)

Avago Technologies
- 12 -
Syncro CS 9361-8i and Syncro CS 9380-8e Controllers User Guide
November 2014 Chapter 2: Hardware and Software Setup
Syncro CS 9361-8i Cluster-in-a-Box Hardware Setup
The following table describes the jumpers and connectors on the Syncro CS 9361-8i controller.
Table 1 Syncro CS 9361-8i Controller Jumpers and Connectors
Jumper/
Connector
Type Description
J1A2
IPMI-style I
2
C connector for Ports 4 to 7
3-pin connector
Supports SCSI Enclosure Services (SES) over I
2
C through an internal
I 2 C backplane cable.
J1A4 IPMI-style I 2 C connector for Ports 0 to 3 3-pin connector
Supports SES over I
2
C through an internal I
2
C backplane cable.
J1B1 Individual PHY and drive fault indication
header
Ports 0 to 3
Ports 4 to 7
2x8-pin header
Connects to an LED that indicates whether a drive is in a fault
condition. One LED exists per port. When lit, each LED indicates
the corresponding drive has failed or is in the Unconfigu-Bad state.
The LEDs function in a direct-attach configuration (no SAS
expanders exist). Direct attach is defined as a maximum of one
drive connected directly to each port.
The J5A1 connector on the MegaRAID SAS 9361-4i RAID controller
is a single internal port connector.
J2B4 Standard edge card connector The interface between the RAID controller and the host system.
Along with the PCIe ® interface, this connector provides power to
the board and an I
2
C interface connected to the I
2
C bus for the
Intelligent Platform Management Interface (IPMI).
J4B1 CacheVault Flash Module (ONFI) interface 70-pin connector
Connects the RAID controller to a flash module.
J5A1 Dual x4 SAS Port 0 through Port 7 internal
connector Two SFF-8643 mini-SAS HD-4i internal connectors
Connects the controller by cable to SAS drives .
J5B1 LSI Test header 2-pin connector
Reserved for LSI use.
B
-%
3257
3257
YH YH
D N