Avago Technologies Syncro 9361-8i - Manual (Page 22)

Avago Technologies
- 22 -
Syncro CS 9361-8i and Syncro CS 9380-8e Controllers User Guide
November 2014 Chapter 2: Hardware and Software Setup
Syncro CS 9380-8e Two-Server Cluster Hardware Setup
In the figure, Pin 1 is highlighted in red for each jumper.
Figure 10 Card Layout for the Syncro CS 9380-8e Controller
The following table describes the jumpers and the connectors on the Syncro CS 9380-8e controller.
Table 2 Syncro CS 9380-8e Jumpers and Connectors
Jumper/
Connector
Type Description
J1A5 Default Serial boot ROM (SBR) header 2-pin connector
Reserved for LSI use.
J1A6 Global drive fault LED header 2-pin connector
Connects to an LED that indicates activity on the drives connected to
the controller.
J1A8 CPLD header 5-pin connector
Reserved for LSI use.
3_02175-03
J1A11 J4A1 J1A5
J1B4
J1B3
J2B4
J1B2
J1B1
J1A8
J1A6
J1A12
B
-$
YH YH
D N