Avago Technologies Syncro 9361-8i User Manual
Page 14
Avago Technologies
- 14 -
Syncro CS 9361-8i and Syncro CS 9380-8e Controllers User Guide
November 2014
Chapter 2: Hardware and Software Setup
Syncro CS 9361-8i Cluster-in-a-Box Hardware Setup
4.
Ground yourself and then place the Syncro CS controller and the remote mount board on a flat, clean, static-free
surface.
NOTE
If you want to replace a bracket, refer to the Replacing Brackets on
MegaRAID SAS+SATA RAID Controllers Q at
ww.lsi.com/downloads/
for instructions.
5.
Perform the following steps to attach the clip to a BBU-BRACKET-05 remote mount board.
a.
With the remote mount board on a flat, clean, static-free surface, ground yourself, and make sure that the
system is grounded.
b.
Remove the mounting clip and the remote mount board module from the package.
c.
Place the clip and the remote mount board module front-side-up on a flat, clean, static-free surface.
d.
Hold the clip so the screw holes on the clip line up with the screw holes on the remote mount board, as
shown in the following figure.
Figure
3 Installing the Clip on the Remote Mount Board
e.
Secure the clip to the three screw holes with the screws and the nuts.
The screws thread through the front of the clip and the remote mount board.
NOTE
Center the screwdriver carefully to avoid stripping the screw heads. Do
not over-tighten the screws.
A
A
A
Clip
3_00895b-00