Avago Technologies Syncro 9361-8i - Manual (Page 19)

Avago Technologies
- 19 -
Syncro CS 9361-8i and Syncro CS 9380-8e Controllers User Guide
November 2014 Chapter 2: Hardware and Software Setup
Syncro CS 9380-8e Controller Kit
13. Reinstall the cover of the CiB enclosure and reconnect the power cords. Turn on the power to the CiB enclosure.
The firmware takes several seconds to initialize. During this time, the controllers scan the ports.
Refer to the 12Gb/s MegaRAID SAS Software User Guide at http://www.lsi.com/downloads/ for information about
running the configuration utilities and installing the software drivers.
Refer to the Syncro CS 9361-8i and Syncro CS 9380-8e Solution User Guide at http://www.lsi.com/downloads/ for the
procedures used to create the HA-DAS cluster configuration after the hardware is fully configured and the
operating system is installed.
2.3 Syncro CS 9380-8e Controller Kit
The LSI Syncro CS 9380-8e controller kit includes the following items:
— Two Syncro CS 9380-8e controllers
— Two CacheVault Flash Modules 04 (CVFM04) (pre-installed on the controllers)
— Two CacheVault Power Modules 02 (CVPM02)
— Two CVPM02 mounting clips and hardware
— Two CVPM02 extension cables
— Two low-profile brackets
— Syncro CS 9361-8i and Syncro CS 9380-8e Controllers Getting Started Guide
The hardware configuration for the Syncro CS 9380-8e solution requires the following additional hardware that is not
included in the kit:
— Two server modules from the LSI-approved compatibility list. The servers must include network cards.
— One or more JBOD enclosures with SAS disk drives from the LSI-approved compatibility list.
— A monitor and mouse for each server node.
— Network cabling and SAS cabling to connect the servers and JBOD enclosures.