Avago Technologies Syncro 9361-8i - Manual (Page 11)

Avago Technologies
- 11 -
Syncro CS 9361-8i and Syncro CS 9380-8e Controllers User Guide
November 2014 Chapter 2: Hardware and Software Setup
Syncro CS 9361-8i Cluster-in-a-Box Hardware Setup
CAUTION Before you install the Syncro CS controllers, make sure that the CiB
enclosure is disconnected from the power and from any networks.
3. Review the Syncro CS connectors and the jumper settings and change them if necessary.
You usually do not need to change the default factory settings of the jumpers. The following figure shows the
location of the jumpers and connectors on the controller board.
The CVFM04 module comes pre-installed on your Syncro CS 9361-8i controller; however, the module is not
attached in the following figure so that you can see all of the connectors and headers on the controller. Figure 5 ,
Figure 6 , and Figure 7 show the controller with the CVFM04 module installed.
In the figure, Pin 1 is highlighted in red for each jumper.
Figure 2 Layout of the Syncro CS 9361-8i Controller
3_01679-02
J1A2
J2B4
J4B1
J1A4
J1B1
J5B1
J6B1
J6B5 J6B4
J6B6
J6B3
J6B2
J6B7
J5A1