Avago Technologies Syncro 9361-8i User Manual
Page 21
Avago Technologies
- 21 -
Syncro CS 9361-8i and Syncro CS 9380-8e Controllers User Guide
November 2014
Chapter 2: Hardware and Software Setup
Syncro CS 9380-8e Two-Server Cluster Hardware Setup
The following figure shows a high-level diagram of a Syncro CS 9380-8e solution with the controllers connected to
multiple enclosures.
Figure
9 Two-Server Syncro CS 9380-8e Configuration with Multiple Enclosures
2.4
Syncro CS 9380-8e Two-Server Cluster Hardware Setup
Perform the following steps to set up the hardware for a Syncro CS 9380-8e configuration.
1.
Unpack the Syncro CS 9380-8e controllers and the CVPM02 modules from the kit and inspect them for damage.
If any components of the kit appear to be damaged, or if any items are missing from the kit, contact your LSI
Customer and Technical Support representative.
2.
Turn off the power to the server units, disconnect the power cords, and disconnect any network cables.
3.
Remove the covers from the two server units.
Refer to the server documentation for instructions on how to do this.
4.
Review the Syncro CS 9380-8e jumper settings and change them if necessary. Also note the location of the
external Mini-SAS SFF8644 connector J1A12.
You usually do not need to change the default factory settings of the jumpers. The following figure shows the
location of the jumpers and connectors on the controller board.
The CVFM04 module comes pre-installed on the Syncro CS controller; however, the module is not included in the
following figure so that you can see all of the connectors and headers on the controller board.
show the controller with the CVFM04 module installed.
B
6HUYHU1RGH$
6\QFUR&6H
7RS
&RQQHFWRU
%RWWRP
&RQQHFWRU
6HUYHU1RGH%
6\QFUR&6H
'ULYH(QFORVXUH$
([SDQGHU$
&RQQHFWRU
,Q
&RQQHFWRU
,Q
&RQQHFWRU
2XW
([SDQGHU%
&RQQHFWRU
,Q
&RQQHFWRU
,Q
'ULYH(QFORVXUH%
([SDQGHU$
&RQQHFWRU
2XW
([SDQGHU%
&RQQHFWRU
2XW
&RQQHFWRU
,Q
&RQQHFWRU
,Q
&RQQHFWRU
,Q
&RQQHFWRU
,Q
&RQQHFWRU
2XW
7RS
&RQQHFWRU
%RWWRP
&RQQHFWRU