Kyocera Command Center RX - Manual (Page 92)

Management Settings
88 Embedded Web Server
10 Management Settings
This page is accessible when you have logged in the embedded server with
administrator privilege, while network authentication or local authentication is enabled.
If needed, make the following settings: See below for detailed information.
• Job Accounting
• Authentication
• ID Card
• Notification/Report
• History Settings
• SNMP
• System Stamp
• Message Board
• Reset
Job Accounting
This section includes advanced settings for Job Accounting.
Settings
To enable Job Accounting, you must first make the Job Accounting settings.
1.
Click Job Accounting under Management Settings on the navigation menu. The
Settings page opens.
2.
Click Settings button. The Job Accounting Settings page opens. This section
includes the following items for configuration.
Job Accounting
Turn to On to activate Job Accounting.
Job Accounting Access
To execute Job Accounting using network authentication, select Network.
Action Settings
This section includes the following items for configuration:
1. Apply Limit: Select the behavior of processing a job when the maximum print
pages have been reached, from Immediately, Subsequently, and Alert Only.
2. Copier/Printer Count: You can select how the copying and printing page counts
are shown – either the total of both or each of copying and printing individually.
3. Unknown ID Job: Select the behavior of processing a job that has an unknown
account ID or has no account ID, from Permit and Reject.
3.
If you have set Job Accounting to On in step 2 above, Default Counter Limit and
Count by Paper Size are displayed.
Note: Only Default Counter Limit is displayed accrding to the machine.