Kyocera Command Center RX - Manual (Page 31)

Device Settings
User Guide 27
Sleep Rule
If you have selected Energy Saver mode of sleeping, click On of the appropriate
radio button for the interface or device you would like to engage in Energy Saver.
Click Off if you do not want to engage Energy Saver for the interface or device. For
example, if you want the print data received by the network interface always to wake
the machine to continue printing, click Off next to Network.
Auto Sleep
Click Settings button to open the Auto Sleep Settings page. Click On if you want
to use Auto Sleep and click Submit button.
Sleep Timer
Specify the time period in the drop-down list, after that time period the system enters
Auto Sleep Mode.
Power Off Timer
Specifies the time from 1 hour to 1 week after which the system enters the power off
mode, where the device automatically turns off after a certain amount of time
elapses the device was last used.
Power Off Rule
Click On of the appropriate radio button for the interface or device you would like to
engage in power off mode. Click Off if you do not want to engage power off mode
for the interface or device.
Low power Timer
Specifies the time from 1 to 240 minutes after which the system enters the low
power mode, where it reduces the power consumption.
Energy Saver Recovery Level
Select Full Recovery, Normal Recovery, or Power Saving Recovery.
3.
After confirming the settings, click Submit button.
Set Timer
1.
Click Energy Saver/Timer under Device Settings on the navigation menu. The Energy
Saver/Timer Settings page opens.
2.
This page allows the following settings:
Auto Panel Reset
Configures the panel to be automatically reset. Activate this setting to open Panel
Reset Timer and specify the time between 5 and 495 seconds after that the panel
will be automatically reset.
Interrupt Clear Time
This determines the time period before the machine reverts to normal mode, after
the interrupt copy mode has been engaged. The range is 5 to 495 seconds.