Kyocera Command Center RX - Manual (Page 101)

Management Settings
User Guide 97
3.
Configure the ID Card Settings. Select IDM or FeliCa as the ID Card Read Type.
4.
Configure the FeliCa Settings.
System Code 1
Enter the System Code 1 from 0000 to FFFF.
Service Code 1
Enter the Service Code 1 from 0000 to FFFF.
Number of Blocks in Use.
Enter the number of blocks in use from 1 to 255.
System Code 2
Enter the System Code 2 from 0000 to FFFF.
Service Code 2
Enter the Service Code 2 from 0000 to FFFF.
Number of Blocks in Use.
Enter the number of blocks in use from 1 to 255.
Configure the System Code 2 as necessary.
5.
Click Submit button.
Notification/Report
This section includes advanced settings for attentions and reports.
Notification/Report Settings
1.
Click Notification/Report under Management Settings on the navigation menu. The
Notification/Report Settings page opens.
2.
You can configure settings for Management Report. This item is shown only when an
optional Fax kit is installed.
Outgoing FAX Report
Select either On or Off.
Incoming FAX Report
Select either On or Off.
3.
You can configure settings for Send Result Report.
E-mail/Folder
From the drop-down list, select Off, On, or Error Only. If an error occurs during
transmission, Error Only allows a transmission result reported by e-mail and stored
in the folder.