Cancelling direct transmission, Fax tx report, Density – TA Triumph-Adler P-4035 MFP User Manual
Page 63: Duplex, Cancelling direct transmission -24, Fax tx report -24 density -24 duplex -24
3-24
Sending Faxes > FAX TX Report
Cancelling Direct Transmission
During direct transmission, to cancel communication during transmission, press the [
Stop
] key. The originals that have
been scanned are ejected, and the screen returns to the fax default screen. When originals remain in the document
processor, take them out.
FAX TX Report
You can check whether FAX was transmitted properly by printing the report after transmission.
Density
Adjust density. Press the [
▲
] or [
▼
] key to select [Darker +4] to [Lighter -4].
Duplex
Set this to read both sides of the original.
NOTE
In some cases, transmission may take place even if the [
Stop
] key.
Item
Description
Off
Does not print reports.
On
Prints reports.
Error Only
Prints reports only if an error occurs.
NOTE
This setting is displayed if FAX TX Result Reports is set to [Specify Each Job]. For details, refer to
Reports (Send Result) on page 7-5
.
NOTE
When you want to increase the density of the original that has thin density, density needs to be adjusted to Darker.
When you want to reduce the density of the original that has thick density, density needs to be adjusted to Lighter.
Item
Description
1-sided
Set when using a 1-sided sheet original.
2-sided
Set when using a 2-sided sheet original.